Use a miter saw to chop the 1x3s into 16 pieces for the balusters according to the cut list. Adjust the blade to 12 degrees and trim off one end of each baluster, as shown. See more

Lay out eight rough-cut balusters on your work surface, using spacers to set the distance between them—1½ inches in our case. Line up the angled ends against a board. At th… See more

Measure and mark the 6×6 center post according to the dimensions on the cut list. Use a rafter square to transfer the dimensions around the post. Set your circular-sa… See more

The marker will be plenty heavy, but it’s not a bad idea to anchor it with a steel rod. Clamp the post to your work surface and mark the center point of the bottom. Using a ¾-inch sp… See more